Frequency MAF now works Closed loop idle maximum RPM is now 3000 Electronic throttle auto-calibration now works with throttles that have no neutral position Clear HPTE timer and flag on stall Fix scaling issues on LTFT gain table Fix LTFT CLT threshold, now works as intended (keeps LTFT from adjusting…
Tested and fixed throttle auto-calibration on several more throttles Change a setting in throttle driver chip that allows it to run cooler with no detrimental effects Do not start a new log if engine shutdown is active Tweak settings for closed loop idle speed control with throttle by wire.
Changes since last release: CAN IDs now show in decimal and hex Fix a crash when using the signal feature when an input had not yet been set Add poll level option for 36-2+2 decoder Extend dynamic flash to 64k Fuel tables are now dynamic Long Term Fuel Trim (LTFT)…
Changes since last release: Manual throttle testing button for testing with the pedal and throttle with the engine off Red error triangle if throttle or pedal are not calibrated Electronic throttle re-work to add spring tension and friction compensations, and improve PID code Add electronic throttle auto-calibration (automatic spring and…
Throttle table defaults to a 10×1 curve, but will upgrade from old tunes to a 10×10 table Swap phase when poll level tooth isn’t 0 Allow “wait for cam” to work with poll level Fix reported/logged values for ioports for crank/cam to match polarity at the ECU pin Fixed timing…
Changes since last release: ADC sensors set global faults – allows other code modules to detect sensor faults CAN broadcast can broadcast these faults Add CAN logger functionality Wideband O2 control Change warmup logic to ensure slow warmup on cold start Estimate sensor temperature when sensor temperature is low Other…
Changes since last release: Add help data for some items that were missing help Stepper (on AxiomEFI 1000) disabled when power relay is off Crank Taper curve now uses a unit selector for time vs. cycles Red triangle text for dual fuel pressure/temperature Trigger wheel poll level phase was backwards,…
Changes since last release: Fix injector timing table defaults Extend output test mode for on/off/frequency Make Warmup curves dynamic Make cold advance and startup curves dynamic Generate red triangles for configuration errors Use a unit selector for ASE taper to choose seconds vs cycles
Changed since last release: Fix default object sizes in configuration files Make traction curves dynamic Make CAN channels usable for analog inputs Add configurator settings for traction control Add upgrades from old settings to new dynamic settings for traction control Make MAP prediction table dynamic (along with adding upgrades and…
Changes since last release: Fix dwell / max spark duration calculation scaling error Staging uses dynamic tables Injector and Coil disabling features are enabled Nitrous uses dynamic tables Launch retard uses dynamic tables VSS-based launch uses dynamic tables VVT timing uses dynamic tables Lambda target uses dynamic tables
