Firmware – Release 1.0.0 Alpha 29 (20260106)

Throttle table defaults to a 10x1 curve, but will upgrade from old tunes to a 10x10 table
Swap phase when poll level tooth isn't 0
Allow "wait for cam" to work with poll level
Fix reported/logged values for ioports for crank/cam to match polarity at the ECU pin
Fixed timing overrides cranking advance in addition to overriding running advance
Fix reporting of psi/bar for CAN receiving
Brake pedal input added
Add options to Electronic Throttle Control (ETC) to limit by brake pedal, VSS=0
Soften "corners" of ETC sweep test and add a fast blip (mimics rev-matching for downshifts
Add ETC sweep test cancel button
Add fuel consumption units
Re-implement High Power Time Enrichment
Throttle target table and position bias are now dynamic
Add a feature to allow logging of raw ADC channels
Add ETC auto-calibration for finding throttle range of motion (throttle stops)
- Checks for under-voltage, TPSA backwards, motor backwards
Rework voltage MAF support
Support throttles with non-linear position sensors
Change SDcard behavior so it only pops up/mounts with the ECU off if it's in R/W mode