Firmware – Release 1.0.0 Alpha 25 (20251007)

Changes since last release:

Add help data for some items that were missing help
Stepper (on AxiomEFI 1000) disabled when power relay is off
Crank Taper curve now uses a unit selector for time vs. cycles
Red triangle text for dual fuel pressure/temperature
Trigger wheel poll level phase was backwards, this has been fixed
Default VVT decoder option is auto, which uses learn decoder and hides tooth min/max angle settings
Status bits added for VVT learn status
All VVT decoders are now learn decoders
Remove redundant K24A2 decoder settings
GM7X VVT works 0-15 degrees (above 15 it will error)
Add manufacturer names to some decoders
Configurator added for VVT
Warnings on invalid firing order added (requires tuning software uipdate)
4G63 decoder fixed
Cam polarity for non-generic wheels was previously opposite to what it should be. This is fixed. Requires settings change.
Cam decoder can be enabled even when VVT is off. Decoder moved to trigger wheel page from VVT page.
NipponDenso crosstalk filter removed (no longer needed)
Pit lane limiter speed setting is now a 4D capable table
Dynamic table Z-data now has descriptions and tooltips
Default wire colors added (matches Axiom wiring harness) for the 600